Beijing Jinghua Parker Polymerization Machinery Equipment Co., Ltd.
Beijing JHPK Polyurethane Equipment Co., Ltd. All Rights Reserved 京ICP备05052510号-2 Pay attention to us:
Contact information
Equipment Information Hotline:
0086-13801200210
0086-13581710001
After-Sale Service Hotline:
0086-010-60273028
Mail box:info@jhpk.net
info@jhpk-group.com
Polyurethane Foam Spray Machine
Polyurethane Foam Injection Machine
PU Resin Pultrusion Injection System
Polyurea Spraying Equipment
Win-Door Profiles Insulation System
Gun/Pump/Hose and Others
What are the components of the polyurethane spraying machine?
Release time:
2022/06/06
Page view
The complete polyurethane applicator system consists of the following
components:
1. Lifting pump: It is mainly used to pump the raw materials in the raw
material barrel to the booster pump of the main machine of the
polyurethane spraying machine, and the pneumatic motor drives the lifting
bowl to move up and down to pump the raw materials. The part inserted
into the raw material needs special surface treatment, or stainless steel
material is used to increase corrosion resistance. This is a place where
small factories are easy to cut corners, so don't ignore it.
2. Polyurethane spraying machine host: the polyurethane spraying machine
host contains a control system (temperature controller), a booster
system (booster pump), and a heating system (heater);
3. The heat preservation pipe group consist of a transmission pipeline, a
temperature sensor, a temperature switch, a waterproof layer, a heat
preservation lay and a protective layer; The internal pressure of the
high-quality insulation pipe group is as high as 20 + MPa. The selection
of pipes and the pressing of pipe heads are the places where small
factories are easy to cut corners.
4. Polyurethane sprayer: The sprayer is the key component for mixing the
polyurethane AB material. At the sprayer head, the high temperature and
high pressure fluid pressurized by the booster pump and heated by the
heater collides with each other under high pressure. After the stroke
vortex is fully mixed, the sprayer is automatically cleaned. The sprayer
has a high requirement for the precision of the parts, and the high
precision parts make the sprayer well sealed and not easy to be blocked.
5. Power and air supply, air compressor, normally purchased separately
6. Complimentary wearing parts, tools, etc.